Ok i need help now after browsing
 

equipment: linksys router, and DSl speed stream box
networked computers 2
working with computer A .. IP for A is 192.168.1.101

ok.. i have went into my linksys router to forward my ports by enable the port 8000 to point to 192.168.1.101
hit save settings
oh and i set it to tcp
then i did a udp also same thing

then i went into my speedstream router as well
did the forward port crap... as wellll
i start server. and guess what.
get that dreaded message cannot see a server blah blah.. the most hated message in the world..

before i set this silly network up.. i was streaming fine because i only had to deal with one router...

have any clue whats going on?

i also checked with toolbox to see if i was streaming but no go..
but if i goto 192.168.1.101:8000 i can see my admin crap and it says im streamning to it.. noone can connect at all though


HELP!

Hey can anyone help me out pls?

What exactly are you putting in the 'address' box in the output tab of the DSP?

What does the cantheygetin link say?