View Single Post
Old 7th March 2016, 15:47   #4
kfcsmitty
Junior Member
 
Join Date: Mar 2016
Posts: 3
Update:

So I switched from using the x86-unicode dll and used the x86-ansi one and it is actually extracting the files now.

However, the status being displayed is off.

It says "Decompressing XX%" where the % seems to be accurate, but then it lists (0 /XXX MB) where XXX is the amount that has been extracted and the 0 always stays at 0.

Has anyone encountered that before or know of a fix? I would be fine even if there was a way to just show the % and not the #'s.
kfcsmitty is offline   Reply With Quote