How can you make winamp & shoutcast start automatically when windows boots?

Peter Tate · 16th September 2004, 02:16

Boys,

Just install this little gem into Winamp. Then put the source input in your playlist window of Winamp.

I was one asking the same question as I use Line IN for my shoucast. This is great for using all the plugins for winamp to do the compression etc. Problem was if you were out and the power got cut (storm or maintenaince) you could set the computer to reboot and then open Winamp plus the other encoders and servrs for the shout cast. But Winamp would sit there and not play the Line In.

This is what I use

http://www.winamp.com/plugins/browse...&query=restore

Regards
Peter
Station X---www.stationx.com.au

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

16th September 2004, 02:16	#1
Peter Tate Junior Member Join Date: May 2002 Location: Australia Posts: 37	Boys, Just install this little gem into Winamp. Then put the source input in your playlist window of Winamp. I was one asking the same question as I use Line IN for my shoucast. This is great for using all the plugins for winamp to do the compression etc. Problem was if you were out and the power got cut (storm or maintenaince) you could set the computer to reboot and then open Winamp plus the other encoders and servrs for the shout cast. But Winamp would sit there and not play the Line In. This is what I use http://www.winamp.com/plugins/browse...&query=restore Regards Peter Station X---www.stationx.com.au