Progress Bar Question

BlueHabu · 18th July 2005, 21:05

I have a somewhat large installer 330MB compress/550 uncompressed. Using MUI the progress seems to get "stuck" at the point when files are being copied (around 25%) and stays there until all the files are copied (about 3 minutes) . Then it jumps to like 75% to launch a setup exe I have. Then it finishes up.

Any ideas what is going on? I would like the progress bar to move during the time files are being copied over. I very newbish about this stuff. I just took on the installer project where i work

Thanks

JasonFriday13 · 19th July 2005, 04:04

I think it is because the progress bar's maximum value is the number of commands in the install section, and as the commands are carried out the progress bar increases for each command. I have a big installer (250 uncompressed/ 50 compressed) and I noticed this on my installer. The files being copied take a while to execute but the registry commands; INI writing; executing other programs; etc... take almost no time to execute. If you put all your file commands at the end of the section (after all other commands) you will see that the progress bar will jump at the start and then it appears to stop right at the end.

It's just one of those things you have to live with.
One solution I can see is to put a command that takes no time to execute in between the file commands so it looks like the install is constant.

I hope this info helps.

18th July 2005, 21:05	#1
BlueHabu Junior Member Join Date: Jul 2005 Posts: 1	Progress Bar Question I have a somewhat large installer 330MB compress/550 uncompressed. Using MUI the progress seems to get "stuck" at the point when files are being copied (around 25%) and stays there until all the files are copied (about 3 minutes) . Then it jumps to like 75% to launch a setup exe I have. Then it finishes up. Any ideas what is going on? I would like the progress bar to move during the time files are being copied over. I very newbish about this stuff. I just took on the installer project where i work Thanks

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

19th July 2005, 04:04	#2
JasonFriday13 Major Dude Join Date: May 2005 Location: New Zealand Posts: 916	I think it is because the progress bar's maximum value is the number of commands in the install section, and as the commands are carried out the progress bar increases for each command. I have a big installer (250 uncompressed/ 50 compressed) and I noticed this on my installer. The files being copied take a while to execute but the registry commands; INI writing; executing other programs; etc... take almost no time to execute. If you put all your file commands at the end of the section (after all other commands) you will see that the progress bar will jump at the start and then it appears to stop right at the end. It's just one of those things you have to live with. One solution I can see is to put a command that takes no time to execute in between the file commands so it looks like the install is constant. I hope this info helps.