Error when starting shoutcast after rebooting

[csc2ya]

After I rebooted my server earlier, I noticed that shoutcast did not appear to be working.

The way I run shoutcast is via a scheduled task that runs it on boot.

On stopping the task, and attempting to run it manually, I got a message that there was already something listening on port 8000.

I looked in task manager, and noticed sc_serv.exe listed. I ended this, and attempted to run sc_serv.exe manually again. On doing this I got an error prompt referencing sc_serv_basic.conf. http://csc2ya.co.uk/shoutcast.png

On looking into what could be wrong with my files, i've come up blank. Both files have always worked fine up until now. Ideally, I want shoutcast to run as a scheduled task on boot, as it's always done before, but as I can't continue past the error unless I can see it, it appears this way will no longer work.

My configuration files (with any sensitive info removed), are pasted below:

Originally Posted by sc_serv.conf

; NOTE: for any relative paths specified are relative to
; sc_serv and not to where the conf file is being stored


; we use the sc_serv_basic.conf configuration file as the
; base configuration to work from for a public server
include=sc_serv_basic.conf

; due to the way configuration files work we can replace an
; existing value like 'publicserver' with a newer value so
; the following will force any sources to be public which
; allows us to then connect and be listed on the YP
publicserver=always
streamid_1=1
streamauthhash_1=
MaxUser=1000

Originally Posted by sc_serv_basic.conf

; NOTE: for any relative paths specified are relative to
; sc_serv and not to where the conf file is being stored

; here we will setup where the log and other related files
; will be stored. make sure that these folders exist else
; sc_serv will throw an error and will close itself down.
; we will make the logs save to the sc_serv2 directory
logfile=logs\sc_serv.log
w3clog=logs\sc_w3c.log
banfile=control\sc_serv.ban
ripfile=control\sc_serv.rip


; for testing we will make the server only work locally
; (i.e. localhost / 127.0.0.1) though if this is left out
; or set to publicserver=always then we attempt to make a
; connection to the YP for listing - do not forget to add
; in a 'streamauthhash' value for any public streams made
;publicserver=always


; if you're wanting to use a different port to use for any
; connections then you can use this option e.g. to use 80
; otherwise port 8000 is used as the default to listen on.
;portbase=80


; password used by sc_trans or the Winamp dsp plug-in
; NOTE: remember to change this to something else
password=


; password used for accessing the administation pages
; NOTE: remember to change this to something else
adminpassword=