Format for Shoutcast V2 Legacy Encoders?

RadioRookie · 19th November 2016, 17:32

Hi,

I am trying to setup a relay from a feed create from the new Shoutcast and use this stream as a relay source for a secondary feed that I created with a 3rd part Shoutcast stream reseller. They are asking for IP and Port.

However, the new Shoutcast format uses an ID as well. Any ideas of how to properly format these new Shoutcast streams to meet the legacy Shoutcast formats that only require an IP and port?

Thank in advance

VirtualDjMix · 11th February 2018, 12:14

Good morning I'm having a problem to set up a Radio on Radionomy Shoutcast- Radiomanager
I'm putting password and Stream ID the way it asks to do !!
###############################################################
Tip
Legacy encoders do not have the Stream ID field. As a result, fill out your password field then add ":#" and your Stream ID (after the password).
Example: abcde:#123456
I'm putting it in the same way only this one giving error in Radio Boss
I'm doing it like this> password: abcd:#12345 only that error anyway!

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

19th November 2016, 17:32	#1
RadioRookie Junior Member Join Date: May 2012 Posts: 30	Format for Shoutcast V2 Legacy Encoders? Hi, I am trying to setup a relay from a feed create from the new Shoutcast and use this stream as a relay source for a secondary feed that I created with a 3rd part Shoutcast stream reseller. They are asking for IP and Port. However, the new Shoutcast format uses an ID as well. Any ideas of how to properly format these new Shoutcast streams to meet the legacy Shoutcast formats that only require an IP and port? Thank in advance

11th February 2018, 12:14	#2
VirtualDjMix Junior Member Join Date: Mar 2017 Posts: 1	Good morning I'm having a problem to set up a Radio on Radionomy Shoutcast- Radiomanager I'm putting password and Stream ID the way it asks to do !! ############################################################### Tip Legacy encoders do not have the Stream ID field. As a result, fill out your password field then add ":#" and your Stream ID (after the password). Example: abcde:#123456 I'm putting it in the same way only this one giving error in Radio Boss I'm doing it like this> password: abcd:#12345 only that error anyway!