Private-Publlic

[LiLR]

Hi people!!Well I faced a problem...I was broadcasting normally the first days but 1 hr ago I tried to connect, it is connected but in my status sais:server is currently an rpivate.....its not public....in the log of the server it sais im connected but not added!!!why??It is still like that for about 15 minutes .....anyone got any ideas?

[djmastermind]

Make sure that you server is set to be public by doing two things.. Go into your server configuration and look for the following:

; PublicServer can be always, never, or default (the default, heh)
; Any setting other than default will override the public status
; of the source plug-in or of a SHOUTcast server that is being relayed.
PublicServer=always

Also, go into the DJ Tool in WinAmp > output tab > Yellowpages and make sure the box next to "Make This Server public" is checked. You should be okay from now on.

[FesterHead]

Also check if RIPOnly is enabled.

Check out the DNASs sc_serv.ini/conf configuration file for the section (default shown below):

code:
; RIPOnly, when set to Yes, will only allow IP addresses listed in the Reserved

; IP list to connect and relay.  All other connections for listening will be denied.

; This is really only useful for servers whose sole purpose is to provide the

; primary feed to all public relays.  Setting this value to Yes also forces the

; server into Private mode, since listing this server in the directory would

; be pointless.  Default is No.

; RIPOnly=No