Just a shot in the dark... but are you using the same intro file for BOTH streams? If so, that could be your problem. The intro file needs to be encoded at the same samplerate/channels as the stream (using the same bitrate helps too). (ie: two intro files... one encoded at 96kbps/44.100kHz/Stereo and the other at 40kbps/22.050kHz/Mono)
From the config file:
; IntroFile can specify a mp3 file that will be streamed to listeners right
; when they connect before they hear the live stream.
; Note that the intro file MUST be the same samplerate/channels as the
; live stream in order for this to work properly. Although bitrate CAN
; vary, you can use '%d' to specify the bitrate in the filename
; (i.e. C:\intro%d.mp3 would be C:\intro64.mp3 if you are casting at 64kbps).
; The default is no IntroFile
Then be sure to point the config file for each stream to the correct version of the intro file.
I know there's another way to do this, but this was the way that worked easiest for me.
BTW, I personally wouldn't use Encoder 1 for ANYTHING. Very buggy, as posted many times in the forums (like when switching between Winamp Input and Soundcard Input modes). I use Encoder 2 for Output 1, and use Encoder 3 for Output 2.
Last edited by MavMix; 16th September 2004 at 22:17.